#Opensprinkler github dan pro

Interrupts are only needed when you sleep the node!Įverything I talk about here is for always powered nodes, where you do not need to sleep because you are not on batteries. But look closely, most (all?) of MySensors code I have seen for 'inputs' (door, motion, etc.) actually DO NOT use interrupts! Notice the code runs right in the main loop. Which only confused me further (at first).

#Opensprinkler github dan pro

All of Build pages for these type of sensors mention about interrupts only being available on pins 2 and 3 (assuming Arduino Pro Mini, etc.). For me it was getting confused by lots of talk about interrupts (in relation to 'input' type sensors). Video in OP was good for 'beginner' but you very quickly run into other issues. Serial.print('Loop: ') Serial.print(t2-t1) Serial.println(' milliseconds') Serial.print('Setup: ') Serial.print(t2-t1) Serial.println(' milliseconds') Serial.print('Presentation: ') Serial.print(t2-t1) Serial.println(' milliseconds') ĪtSampling(Adafruit_BME280::MODE_FORCED,Īdafruit_BME280::SAMPLING_X1, // temperatureĪdafruit_BME280::SAMPLING_X1, // pressureĪdafruit_BME280::SAMPLING_X1, // humidity report freq for radio signal - pseudo SR_TX_RSSI and SR_UPLINK_QUALITY are available for NRF24 500ms to let the transport send all buffer before sleeping. battery level - BOD set to 1.8V, 2xAA = 3V maxī(1)->setDescription('tssuite_bat') send unit prefixes to controller (i.e. let controller know ambient pressure sensor reports in hPaĪ(3)->setUnitPrefix('hPa') Radio Signal Quality (default child_id 202)Ī(1)->setDescription('tssuite_temp') Ī(2)->setDescription('tssuite_hum') Ī(3)->setDescription('tssuite_press') Ī(4)->setDescription('tssuite_fcast')

disable Forecast on BME280 - not working with OTA conf Off!

#define NODEMANAGER_OTA_CONFIGURATION OFF #define NODEMANAGER_CONDITIONAL_REPORT ON #define MY_SLEEP_TRANSPORT_RECONNECT_TIMEOUT_MS 2000 #define MY_TRANSPORT_UPLINK_CHECK_DISABLED I'm trying to get the battery level percentage reported but only get battery voltage.